Sup0108 A Deployment Or Update Operation Is Already In Progress Best ⭐

: Navigate to the iDRAC Dashboard. In the right-hand Quick Links panel, click Reset iDRAC . Via SSH/CLI : Run the command: racadm racreset Use code with caution.

: If a stuck RAM drive is the culprit, a full power cycle (cold boot) of the system will clear it. Update Firmware

Log back into the iDRAC Web Interface and verify the job queue is empty under > Job Queue . 3. Execute a System Cold Boot : Navigate to the iDRAC Dashboard

If you have access via SSH or local command line, run the following RACADM command: racadm racreset Use code with caution.

Configure your deployment tools to queue jobs sequentially. Never allow multiple automated workflows to trigger updates to the same target environment simultaneously. Optimize Network and Timeout Thresholds : If a stuck RAM drive is the

: If a firmware upgrade has left a "RAM drive" lock on the host OS, a complete system cold boot (power off and on) may be required to clear it. Context and Causes

sfdx force:mdapi:cancel -i <deploymentId> -u <target_org> Execute a System Cold Boot If you have

: During operating system-based updates, the iDRAC installer temporarily mounts a virtual RAM drive onto the host OS to extract firmware binaries. If this RAM drive isn't unmounted properly, future upgrade paths remain blocked. Best Methods to Fix the SUP0108 Error 1. Perform a Soft Reset on iDRAC

The you are attempting to update (e.g., BIOS, RAID controller, or iDRAC firmware). Share public link

This article outlines why this error happens and provides a breakdown of the best troubleshooting methods to clear the block and successfully update your system. What Causes the SUP0108 Error?

are you trying to update (e.g., BIOS, PERC, NIC)? What is your current iDRAC version ? Is this a VxRail system or a standard PowerEdge server? I can give you more specific, tailored advice.