Connect the low-voltage output cable from the transformer to the terminal block located at either the top or bottom end of the rail.
If you are a homeowner seeking to have a Levant installed, you should contact ThyssenKrupp or a local, authorized accessibility equipment provider. If you are an installer seeking the official manual, you must request it directly from ThyssenKrupp through your professional channels, as it is not a publicly available document.
: Power drill, socket set, level, and tape measure.
Use the armrest joystick to drive the lift up and down the track. thyssenkrupp levant stair lift installation manual full
The rail is the foundation of the Levant system. It must be perfectly straight to prevent motor strain. Place the rail sections on the stairs. Join sections using the provided splice plates and bolts. Tighten bolts until the rail sections are flush. Secure the mounting brackets (feet) to the treads. Ensure at least two screws per bracket for stability. Step 2: Installing the Drive Unit
Height-adjustable brackets that clamp to the rail and screw into the stairs.
This comprehensive guide serves as an reference overview of the installation process, alignment procedures, and troubleshooting protocols typically found in the official technical manual. 1. Pre-Installation and Site Inspection Connect the low-voltage output cable from the transformer
The ThyssenKrupp Levant is designed for ease of use, but following the full installation manual is critical. Proper installation ensures that the Levant provides safe and reliable mobility within your home.
Distribute the brackets evenly along the rail. As a rule of thumb, place one bracket on the first step, one on the top step, and one every 3 to 4 steps in between.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. : Power drill, socket set, level, and tape measure
Slide the internal splice bars into the rail channels. Tighten the joint bolts securely using an Allen wrench to ensure a seamless seam. Any bump at the rail joint will cause premature wear on the drive rollers.
I can provide the exact technical specs or wiring diagrams you need. Share public link
Remove the temporary end-stop plate from the bottom (or top) of the rail.
The lift brackets secure directly into the stair treads, not the wall. Ensure the treads can handle a concentrated downward load. Clearance Checklist Clearance Parameter Minimum Requirement Staircase Width 29 inches (740 mm)