V2000-c Rfid Access Control User Manual 📍

Adjust how long the door remains unlocked after a valid credential swipe. Enter Programming Mode. Press 4 .

In programming mode, press 3 + 1 + # . Card AND PIN Mode: In programming mode, press 3 + 2 + # .

Always disconnect the power supply before wiring the device to prevent short circuits. Wire Color Codes and Functions V2000-c Rfid Access Control User Manual

Proper installation is crucial for the security of your premises. 3.1 Mounting

Ensure the card type (EM vs IC) matches the reader frequency and that there is no metal interference behind the mounting surface. Adjust how long the door remains unlocked after

To configure the unit, you must enter programming mode: * → [Master Code] → # (The yellow LED will light up, indicating you are in programming mode) . 4.2 Changing the Master Code Enter Programming Mode: * 123456 # Press 0 → [New 6-digit Master Code] → # Repeat [New 6-digit Master Code] → # Exit: * 4.3 Adding Users (Cards or PINs) Enter Programming Mode. Press 1 → [Read Cards] → # → * Add PIN Only: Enter Programming Mode. Press 1 → [Enter 4-6 digit PIN] → # → * 4.4 Deleting Users Delete a Card: Enter Programming Mode. Press 2 → [Read Card] → # → * Delete by PIN: Enter Programming Mode. Press 2 → [Enter PIN] → # → * 4.5 Setting Door Relay Time To adjust how long the door stays unlocked: Enter Programming Mode. Press 4 → [0-99 seconds] → # → * 5. Troubleshooting & Tips

| Status | LED Color | Buzzer | | :--- | :--- | :--- | | Standby | Red (solid) | None | | Card read OK | Green (1 flash) | 1 short beep | | Access denied | Red (3 flashes) | 3 long beeps | | Programming mode | Orange/Flashing | Double beep | In programming mode, press 3 + 1 + #

1.0 Last Updated: 2026 Applies to: V2000-C Standalone RFID Access Control System