Xizi Otis Elevator Manual — Fixed ((better))

Clean the door sills to ensure the door panels can close fully without mechanical resistance.

To fix any manual-indicated fault, you must first interface with the system to read the error logs. Accessing the Fault Log Connect the Otis Service Tool to the MCB board. Navigate to the monitor menu: .

Complete Troubleshooting Guide: Xizi Otis Elevator Manual Fixed

：

Not every elevator problem can or should be resolved by in-house maintenance staff. Some scenarios demand professional intervention.

如果电梯外呼显示横杠“-”且不能运行，必须在服务器中手动进入 M-1-3-3-1 等路径执行 DCS 操作。此操作会关门运行收集门锁和安全回路信号。DCS 无法正常完成常常是因为门锁回路接触不良，必须手动打磨触点或更换继电器。

Please discard any earlier versions of the Xizi Otis manual. The is now available. xizi otis elevator manual fixed

Misaligned door zone sensors or malfunctioning leveling magnets. Fix: Inspect the leveling sensors on the car top. Check the magnets in the hoistway.

This article provides that bridge. We will explore the most common Xizi Otis elevator system failures (focusing on the OH-CON, OH6000, and SkyTouch series), why the standard manual fails, and the that veteran technicians use to clear faults permanently.

5.1 Isolate Automatic Dispatch

This guide provides a comprehensive overview of how to interpret, troubleshoot, and fix common Xizi Otis elevator faults, based on standard service manual diagnostics. Disclaimer

Check the dynamic braking resistor connections. Inspect the main drive inverter modules for burn marks or a distinct electrical odor. Verify that incoming building voltage matches the elevator nameplate specifications. Fault Code: E10 / E11 (Door Interlock Fault)

Fixing problems after they occur is necessary, but preventing them entirely is far more efficient and cost-effective. The Xizi Otis maintenance philosophy, backed by a workforce where nearly half of all employees are dedicated to maintenance and repair, emphasizes structured preventive care. Clean the door sills to ensure the door

Turn off the main power and check the resistance of the braking resistor using a multimeter. Replace if open-circuit.